31-07-2021, 05:47 PM
Duncan,
You may have already done this, but , using photo shop to produce a layered rectangle to sit exactly over the space between two spokes,and then move and rotate the rectangle to align with the bottom edge of the tank and scaling it, the bottom edge of the tank come out at 7.5 inches if I did my sums correctly? It is then possible, I think to scale the rest of it. Anyway, you get my drift.
All the very best with this project.
Bryan
You may have already done this, but , using photo shop to produce a layered rectangle to sit exactly over the space between two spokes,and then move and rotate the rectangle to align with the bottom edge of the tank and scaling it, the bottom edge of the tank come out at 7.5 inches if I did my sums correctly? It is then possible, I think to scale the rest of it. Anyway, you get my drift.
All the very best with this project.
Bryan