10-05-2021, 10:28 PM
A good point, Dave, about lapping.
I have now lowered the fingers and are all just under 1.25", being 1.16", 1.19" and 1.2". Everything operates smoothly on the bench.
I shall leave them at this until the flywheel is in the engine and I can measure the height from the bell housing: unless others' experience would mean that I have now set the fingers too low.
Regards,
Jamie
I have now lowered the fingers and are all just under 1.25", being 1.16", 1.19" and 1.2". Everything operates smoothly on the bench.
I shall leave them at this until the flywheel is in the engine and I can measure the height from the bell housing: unless others' experience would mean that I have now set the fingers too low.
Regards,
Jamie