27-04-2021, 09:52 AM
(This post was last modified: 27-04-2021, 09:57 AM by Parazine.
Edit Reason: additional info
)
(26-04-2021, 08:48 PM)Vancevr Wrote: i have found that clutch pedal works more like a on/off switch than a pedal
Hmm, that sounds suspiciously like an Austin 7 to me....
You will get used to it - it may be that the clutch surfaces are dirty/oily/rusty, especially if the car hasn't had a lot of use recently, so it may improve.
Bulb should be a 6V, 3W MES, Lucas type LLB990, available here:
Bulb Screw Type 6v 3w Single Contact MES E10 LLB990 (holden.co.uk)
This assumes there is no series resistor in circuit with the bulb (check on your panel).
You will have local suppliers, able to supply at minimal shipment cost.