26-04-2021, 05:40 PM
Hi there, I recently changed the cylinders on the front wheels of my A7, which has the 1960s Morris hydraulic conversion two of them were a bit rusty one being seized. So whilst I was there, I bought new shoes and had the Girling drums cleaned up and take out the ridges. The problem that I have after a good bleed is that with the car jacked up and my wife applying the brake pedal I can turn the front wheels with a bit of effort by hand. Could it be the master cylinder not effective? although it's not leaking. I have checked the wheel cylinders which move in and out by about 1/8 is that good or bad. The snail adjusters are fully turned out.
The minimal bight that I do have is at the end of the travel on the foot brake
I would appreciate any help.
Regards RPM
The minimal bight that I do have is at the end of the travel on the foot brake
I would appreciate any help.
Regards RPM