Rear Hub Removal.

[Bob Culver]

I would never dream of paying L45 for a jig. Some scrap yards here will sell steel oddments for little more than what they pay. A circle can be cut out of a plate by drilling multple small holes and an angle iron bar attached to. I chance to have a lathe and have just made one by enlarging the centre of the backplate off a larger car, with the refinement that a neat fit over centre. Some were advocating a whopping 150 ib ft......... A bit much for the pry bar method. On Girling cars can try wedging the djusters.
If removing the whole axle slacken in place first.