| The following warnings occurred: | ||||||||||||
Warning [2] Undefined variable $search_thread - Line: 60 - File: showthread.php(1617) : eval()'d code PHP 8.1.31 (Linux)
|
|
bending gear lever - how?
|
22-03-2021, 02:26 PM
(This post was last modified: 22-03-2021, 02:27 PM by Nick Lettington.)
In order to get the flat steel for my roof hot enough to bend, I pushed a length of scaffold tube over the flat held in a vice and fired a basic plumbers blow lamp into the end. The scaffold tube shields the flame allowing the steel to get much hotter... and it's simple to slip it back a touch and pull the bend.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
bending gear lever - how? - by JonE - 22-03-2021, 10:36 AM
RE: bending gear lever - how? - by Hedd_Jones - 22-03-2021, 11:32 AM
RE: bending gear lever - how? - by Howard Wright - 22-03-2021, 11:46 AM
RE: bending gear lever - how? - by JonE - 22-03-2021, 12:39 PM
RE: bending gear lever - how? - by Nick Lettington - 22-03-2021, 02:26 PM
RE: bending gear lever - how? - by TomHunt - 22-03-2021, 02:53 PM
RE: bending gear lever - how? - by "Slack Alice" Simon - 22-03-2021, 04:00 PM
RE: bending gear lever - how? - by Parazine - 22-03-2021, 04:45 PM
RE: bending gear lever - how? - by Nick Turley - 22-03-2021, 09:37 PM
RE: bending gear lever - how? - by Chris KC - 22-03-2021, 10:30 PM
RE: bending gear lever - how? - by Duncan Grimmond - 23-03-2021, 01:04 AM
RE: bending gear lever - how? - by Derek Sheldon - 23-03-2021, 08:58 AM
RE: bending gear lever - how? - by Andy Bennett - 23-03-2021, 09:23 AM
|
