20-03-2021, 08:48 AM
Been a little while since I last updated things... due to covid and other such things progress has been sporadic but still steady. Here is where I am at.
The skin has been fitted to the floorpan then trimmed to the correct dimensions. The cockpit and boot have been wired and and the bottom edge of the car has had its final trim and been folded under. The bonnet has been made using some original bonnet hinges and the near side panel has been made. I have also made a start on the instrument panel. The rear of the tail is now finished and has a steel floor fitted. Next on the list is to finish the instrument panel, make the off side bonnet panel and make the timber seat back framing.
20210129_114234.jpg (Size: 232.51 KB / Downloads: 418)
20210129_125411.jpg (Size: 338.34 KB / Downloads: 419)
20210129_125444.jpg (Size: 387.33 KB / Downloads: 420)
20210226_130052.jpg (Size: 165.23 KB / Downloads: 420)
The skin has been fitted to the floorpan then trimmed to the correct dimensions. The cockpit and boot have been wired and and the bottom edge of the car has had its final trim and been folded under. The bonnet has been made using some original bonnet hinges and the near side panel has been made. I have also made a start on the instrument panel. The rear of the tail is now finished and has a steel floor fitted. Next on the list is to finish the instrument panel, make the off side bonnet panel and make the timber seat back framing.
20210129_114234.jpg (Size: 232.51 KB / Downloads: 418)
20210129_125411.jpg (Size: 338.34 KB / Downloads: 419)
20210129_125444.jpg (Size: 387.33 KB / Downloads: 420)
20210226_130052.jpg (Size: 165.23 KB / Downloads: 420)