19-03-2021, 08:42 PM
As far as I know, the weakest is Threadlock, then Studlock, and then Bearing Fit. I use Threadlock as a sealant on all pipe joints involving fuel, it works well.
I use silicon gaskets on the base joint, though some do not like them. I would not use silicon products on the base joint, maybe would use Wellseal if using a paper gasket.
Threads on the bloc - I'd use the middle strength Loctite. If I knew it leaked. But if it leaked any more than a slight weep, I would probably have Helicoiled it.
I use silicon gaskets on the base joint, though some do not like them. I would not use silicon products on the base joint, maybe would use Wellseal if using a paper gasket.
Threads on the bloc - I'd use the middle strength Loctite. If I knew it leaked. But if it leaked any more than a slight weep, I would probably have Helicoiled it.