18-03-2021, 10:10 AM
(This post was last modified: 18-03-2021, 10:13 AM by Nick Lettington.
Edit Reason: Proof reader is on strike ... as is the memory!
)
Hi Peter
I suspect from the cane cutter story that you don't have a standard UK car? With 2 plates 14" apart I'm guessing it has 4 seats? There's a thread on how to post photos, but if you want to email a picture or two to me at cyt660@hotmail.co.uk I will post them on here...
I used D section mild steel tube bent in an adapted plumbers pipe bender as that is what the last remaining part of my old roof was. It may be different on a locally bodied car... The tricky bit was the flat bar sections that link the hoops.
I suspect from the cane cutter story that you don't have a standard UK car? With 2 plates 14" apart I'm guessing it has 4 seats? There's a thread on how to post photos, but if you want to email a picture or two to me at cyt660@hotmail.co.uk I will post them on here...
I used D section mild steel tube bent in an adapted plumbers pipe bender as that is what the last remaining part of my old roof was. It may be different on a locally bodied car... The tricky bit was the flat bar sections that link the hoops.