17-02-2021, 07:07 PM
Yes, but leaving crank in. Its all largely "rebuilt" sic and doesn't look like it has run, but I've taken conrods off and will use all new bolts, replace strainers had been re-used and put it upside down) And there was a lot of play on the camshaft. The peg fine... but will do the tap thing.
Presses aren't cheap, but I'm wondering on the spec of a three leg puller as per Jim's experience. i.e. is it technically winging it, or is a 100mm or 150mm one perfectly up to the job? I suppose one could put a disc of hardboard behind the gear wheel.
Presses aren't cheap, but I'm wondering on the spec of a three leg puller as per Jim's experience. i.e. is it technically winging it, or is a 100mm or 150mm one perfectly up to the job? I suppose one could put a disc of hardboard behind the gear wheel.