06-02-2021, 08:26 PM
(This post was last modified: 06-02-2021, 10:30 PM by Bob Culver.)
despite 1935 I take it the bearings are full width. In the Seven application the reverse fitting would seem OK. This might avoid fiddling with shims. Whiist the bearings should not be loose seems to me preload endangers the frail lip.
I have an NSK manual whcih indicates that random bearings of standard tolerance would give slight clearance, and, unless preload is specifically required as for a machine tool spindle, this is recommended.
I have an NSK manual whcih indicates that random bearings of standard tolerance would give slight clearance, and, unless preload is specifically required as for a machine tool spindle, this is recommended.