The following warnings occurred:
Warning [2] Undefined variable $search_thread - Line: 60 - File: showthread.php(1617) : eval()'d code PHP 8.1.31 (Linux)
File Line Function
/inc/class_error.php 153 errorHandler->error
/showthread.php(1617) : eval()'d code 60 errorHandler->error_callback
/showthread.php 1617 eval




Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Use of Phoenix pressure fed 11/2" crank in a magneto crankxase
#5
(08-01-2021, 02:38 AM)jr2766 Wrote: Thanks for taking the time t reply Charles
I have access to a casting - do you have a sketch of the assembly?
Cheers
Jim (runcimans@westnet.com.au)


Jim

I'll email you something later.
It's essentially a round bar of aluminium with a 7/8 blind hole to accommodate the oil feed dog. It's turned down to make a lip at the timing chest end to allow it to bolt on. The front end has a suitable lip seal fitted and the original thin steel plate that held the felt seal, now helps to retain the seal. Oil is feed into the bore via a drilling with a 1/2 BSP fitting on the outside.
I've got a new casting from Dave Dye for the whole oil bottle, with a starting handle and will need to machine that up in due course for the 10 stud crankcase


.jpg   eng1.jpg (Size: 280.54 KB / Downloads: 505)


c
Reply


Messages In This Thread
RE: Use of Phoenix pressure fed 11/2" crank in a magneto crankxase - by Charles P - 08-01-2021, 11:49 AM

Forum Jump:


Users browsing this thread: 3 Guest(s)