07-01-2021, 01:25 PM
(07-01-2021, 08:16 AM)jr2766 Wrote: I am very new to this forum and will be grateful for any advice
Can anyone advise if the above drank can be used in a magneto engine crankcase. From my observation one obvious difference is the pressure fed nose casting which will differ from the coil engine. Can anyone suggest where such a casting might be sourced?
Thanks
Jim
Yes, it can be used and it does fit.
There are articles in the Companion and online about the process for fitting one into a coil engine and it's broadly the same. As for the nose piece I machined one from a lump of aluminium so never bothered to see who makes them.
C