29-12-2020, 06:38 PM
(This post was last modified: 29-12-2020, 06:41 PM by Geoff Halstead.)
Everything made for the jig as in photo, just need a few minutes with slitting disk then a few MIG tacks and done.
Did so this afternoon but one of my tacks didn’t survive a tug test
A couple of additions became apparent when using it, they to be revealed in a video once done.
It was the first time using the Clarke welder since extending the power leads from the near useless 1.5m to 3m using convoluted tubing.
That tubing is nowhere near as flexible as original, but the torch can be made to swivel at the end so easy to position/point.
Geoff - Continue tomorrow as I gave up in disgust.
Did so this afternoon but one of my tacks didn’t survive a tug test
A couple of additions became apparent when using it, they to be revealed in a video once done.
It was the first time using the Clarke welder since extending the power leads from the near useless 1.5m to 3m using convoluted tubing.
That tubing is nowhere near as flexible as original, but the torch can be made to swivel at the end so easy to position/point.
Geoff - Continue tomorrow as I gave up in disgust.