16-01-2018, 01:36 PM
(This post was last modified: 16-01-2018, 01:37 PM by Reckless Rat.)
Apparently this tool exists in two forms, the UNIBURR (part n° 1819) and the UNIBURR + (part n° 1816). The former is only suitable for mild steel, whilst the latter claims to be OK for hardened studs and stainless. The recommendation is that a very slow speed be used with pressure. The advert shows it as suitable for square bar but I am sceptical. The Amazon reviews seem about right.
It will be a very expensive experience if it turns out to be a load of tat. Caveat emptor.
It will be a very expensive experience if it turns out to be a load of tat. Caveat emptor.