Flashing Indicator Installation Design

[John Mason]

I have a negative earth 6 volt Ruby on which I put flashing indicators on some years aga (before LEDs were readily available). I also wanted the original semaphore signals to work. Electriickery is not really my thing and when first done I had flashers doing a go slow and semaphores going up and down. I got around the problem by fitting relays and having two individual separate circuits . Nearside and offside with a flasher unit for each circuit. It also Incorporates 4 way Hazard lights the only difference being instead of flashing both at the front and then at the rear. My hazards flash nearside front and rear followed by offside front and rear. This is more effective as when viewed from front or rear the lights flash side to side. I must however state this is not fully legal in the UK.

John Mason.