03-11-2020, 10:02 AM
Hi Jamie
With the Ruby clutch I think you may have mousetrap springs which will prevent the following operation. I think some people ditch the springs?
I drilled and tapped for grub screws that could be adjusted from the outside. Assemble the clutch then pull back each toggle, adjust then check the height above the crankcase lip. Once happy I marked the height, Loctite the screws and punched the edge to be sure. If the slot of the screw is perpendicular to the axis of the toggle wear hopefully won’t be a problem.
Cheers
Howard
With the Ruby clutch I think you may have mousetrap springs which will prevent the following operation. I think some people ditch the springs?
I drilled and tapped for grub screws that could be adjusted from the outside. Assemble the clutch then pull back each toggle, adjust then check the height above the crankcase lip. Once happy I marked the height, Loctite the screws and punched the edge to be sure. If the slot of the screw is perpendicular to the axis of the toggle wear hopefully won’t be a problem.
Cheers
Howard