09-01-2018, 06:54 AM
(09-01-2018, 05:45 AM)Barker Wrote: Because Phoenix are most likely to do a proper job, re-nitrating the big end journals plus come up with the proper resized shell bearings for the connecting rods. You will need to check with them that the shells on the connecting rods have been resized with the reground crank. I have had this work done by them.
Phoenix are a decent outfit but a competent machine shop can grind a crank, resize rods and as has been said, a 10 thou grind won't go through the nitriding.
Yes, if you want to go further than 10 thou then the risk of going through the casing warrants their attention.
Charles