The following warnings occurred:
Warning [2] Undefined variable $search_thread - Line: 60 - File: showthread.php(1617) : eval()'d code PHP 8.1.31 (Linux)
File Line Function
/inc/class_error.php 153 errorHandler->error
/showthread.php(1617) : eval()'d code 60 errorHandler->error_callback
/showthread.php 1617 eval



Austinsevenfriends › Austin Seven Friends Forum › Forum chat... v
Rear main bearing - fitting

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Rear main bearing - fitting
Bob Culver Offline
dogged member, NZ
*****
Joined: Aug 2017 Posts: 2,748 Threads: 31
Reputation: 95
Location: Auckland, NZ
#8
19-10-2020, 08:08 PM
Preservation of the front lip is paramount. Less potential brute force involved preinstalled. Provides a check of fit, opportunity to check clearance to flywheel etc.
(Outer housings are seldom truly circular. With a close tolerance bearing, tighter than Austin spec fit on shaft, may require some patience and lots of revolving of the crank to enter the outer.)
Reply


Messages In This Thread
Rear main bearing - fitting - by Mick Hanna - 19-10-2020, 12:57 PM
RE: Rear main bearing - fitting - by Parazine - 19-10-2020, 01:44 PM
RE: Rear main bearing - fitting - by Steve Jones - 19-10-2020, 01:59 PM
RE: Rear main bearing - fitting - by Chris KC - 19-10-2020, 02:55 PM
RE: Rear main bearing - fitting - by Mick Hanna - 19-10-2020, 03:08 PM
RE: Rear main bearing - fitting - by Chris KC - 19-10-2020, 03:52 PM
RE: Rear main bearing - fitting - by David Witton - 19-10-2020, 06:04 PM
RE: Rear main bearing - fitting - by Bob Culver - 19-10-2020, 08:08 PM
RE: Rear main bearing - fitting - by Ian Williams - 19-10-2020, 08:17 PM
RE: Rear main bearing - fitting - by Tony Press - 19-10-2020, 11:26 PM
RE: Rear main bearing - fitting - by Mick Hanna - 20-10-2020, 10:30 AM
RE: Rear main bearing - fitting - by Mick Hanna - 23-10-2020, 04:12 PM
RE: Rear main bearing - fitting - by Tony Press - 23-10-2020, 10:22 PM
RE: Rear main bearing - fitting - by Mick Hanna - 24-10-2020, 10:38 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)