| The following warnings occurred: | ||||||||||||
Warning [2] Undefined variable $search_thread - Line: 60 - File: showthread.php(1617) : eval()'d code PHP 8.1.31 (Linux)
|
|
Manifold stud sheared
|
16-10-2020, 07:38 AM
I know that this is an older thread, but I had to drill out a snap stud as well recently, this in the crankcase. As it was too large to fit into my bench drill, I used the bench drill to put a hole in a thick steel plate. I then aligned this carefully over the broken stud and clamped it firmly with a sash cramp. This enabled me to drill the stud out accurately. The thread was manngled, so needed to be Helicoiled.
Regards, Jamie. |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Manifold stud sheared - by jamesheath - 22-08-2020, 02:40 PM
RE: Manifold stud sheared - by bob46320 - 22-08-2020, 03:00 PM
RE: Manifold stud sheared - by dickie65 - 22-08-2020, 07:41 PM
RE: Manifold stud sheared - by Stuart Giles - 22-08-2020, 10:10 PM
RE: Manifold stud sheared - by Chris KC - 22-08-2020, 10:17 PM
RE: Manifold stud sheared - by jamesheath - 03-09-2020, 09:02 PM
RE: Manifold stud sheared - by Colin Morgan - 03-09-2020, 09:24 PM
RE: Manifold stud sheared - by Steve Parkin - 15-10-2020, 11:31 PM
RE: Manifold stud sheared - by Jamie - 16-10-2020, 07:38 AM
RE: Manifold stud sheared - by John Mason - 16-10-2020, 09:28 AM
RE: Manifold stud sheared - by Chris Garner - 16-10-2020, 10:38 AM
RE: Manifold stud sheared - by Rick F - 16-10-2020, 12:20 PM
RE: Manifold stud sheared - by dickie65 - 16-10-2020, 04:54 PM
|
