13-10-2020, 01:42 PM
Thanks Colin
A bit of lateral thinking !
I suspect that A7CA drawing is one of the ones in line to be re-digitised with better resolution.
Time to jack up the car a bit higher and dive in again with the tape measure.
When I finally get the cross shaft together I plan to share the detailed assembly drawing I an currently preparing. There does seem to be conflicting information about the number of felts and their positioning. If anyone knows for sure where the single cup shaped washer/felt ( 1 inch ID) goes, I would be interested.
A bit of lateral thinking !
I suspect that A7CA drawing is one of the ones in line to be re-digitised with better resolution.
Time to jack up the car a bit higher and dive in again with the tape measure.
When I finally get the cross shaft together I plan to share the detailed assembly drawing I an currently preparing. There does seem to be conflicting information about the number of felts and their positioning. If anyone knows for sure where the single cup shaped washer/felt ( 1 inch ID) goes, I would be interested.