22-09-2020, 09:14 PM
That is an idea! I have some hex body rivnuts that I could try, but I ran an M6 nut uo the thread with little effort.....
The bonnet trial fitting (easy with no paint!) went ok with the correct way up bracket.The side clips were a bit tight and the bonnet sits too high behind the filler cap. I think if you tighten the centre bolt too much of course it bends the extremities of the hinge up....hence the need for spacers.The new rubber seals appear as if they are too thick and it is tempting to carve a bit out of them....
I will try and post pictures tomorrow.
The bonnet trial fitting (easy with no paint!) went ok with the correct way up bracket.The side clips were a bit tight and the bonnet sits too high behind the filler cap. I think if you tighten the centre bolt too much of course it bends the extremities of the hinge up....hence the need for spacers.The new rubber seals appear as if they are too thick and it is tempting to carve a bit out of them....
I will try and post pictures tomorrow.