22-09-2020, 09:27 AM
Only one problem....the thread on the hold down is cream crackered for the essential last half inch.....that is why the channel was upside down perhaps. I may have to die it down to 3/16.....not a good solution.
While the bonnet is off, how do you get the hold down bit off the centre hinge? I have not disassembled that bit, although the sides are separated I imagine the pin drives out and the bits fall apart....?
While the bonnet is off, how do you get the hold down bit off the centre hinge? I have not disassembled that bit, although the sides are separated I imagine the pin drives out and the bits fall apart....?