08-09-2020, 05:19 PM
Does the clutch centre plate spline match the gearbox or is it perhaps too long and bottoming, thus preventing full disengagement?
To test this, loosen the gearbox nuts off slightly and allow the gearbox to move backwards a small amount (1/8"), if this stops the crunch you should space the gearbox back accordingly or remove material from the centre plate spline.
To test this, loosen the gearbox nuts off slightly and allow the gearbox to move backwards a small amount (1/8"), if this stops the crunch you should space the gearbox back accordingly or remove material from the centre plate spline.