03-08-2020, 10:15 AM
You don't need to remove the ball just to straighten the steering side tube. Just take the 1/4" BSF nut and bolt out of the side tube and that will disconnect the tube from the ball. To replace the bolt in the tube, use a screwdriver which will just fit through the hole in the tube, fit the rod end on the ball and you will see that the rod end and tube hole are about 5mm from being aligned. So take the flat blade end of your screwdriver and twist through 90 degrees so that both holes line up. You can then push the bolt through the hole, pushing the screwdriver out at the same time.