02-08-2020, 08:29 PM
(This post was last modified: 02-08-2020, 08:37 PM by Bob Culver.)
The traditional method was to force a heavay piece of metal(sledge hammer head,, axe etc) hard against one side of the metal encasing the taper and sharply strike the opposite with a moderate hammer. If one or two shots dont work do not persist.
Some use a carpenters cramp to assemble the drag link. I use two long thin threaded rods and a couple of end plates.
Some use a carpenters cramp to assemble the drag link. I use two long thin threaded rods and a couple of end plates.