29-07-2020, 08:35 AM
The Speedex has a bonnet strap which seems a bit out of character.
The four corners of the bonnet also seem to want holding to the frame on either side, so it keeps the shape.
I've looked at Dzus but it appears that the fixing needs to be in a position where the underlying point is right on a steel tube (frame) under the outer alloy.
I've got some alloy rivnuts but wonder whether the on/off requirements are too much for such a thread.
what would you use that enables a quick release of sorts, but is quite minimalist from the outer view? I'm presuming it's going to need to go through the entire tube, but be relatively thin so not to weaken.
The four corners of the bonnet also seem to want holding to the frame on either side, so it keeps the shape.
I've looked at Dzus but it appears that the fixing needs to be in a position where the underlying point is right on a steel tube (frame) under the outer alloy.
I've got some alloy rivnuts but wonder whether the on/off requirements are too much for such a thread.
what would you use that enables a quick release of sorts, but is quite minimalist from the outer view? I'm presuming it's going to need to go through the entire tube, but be relatively thin so not to weaken.