25-07-2020, 02:35 PM
I know there have been some good things written about whether to have easily-releasable wires from an additional connector block, or just have long wires so the panel can be flipped out easily.
Any ardent supporters of either, or good housekeeping tips in this department?
I realise ammeters probably want to have undisturbed wiring runs, but thinking particularly of PLC switch terminals, which I don't particularly like fiddling with once in!
Making up loom components so have no loom constraints. (Ones in the past always seem too short)
Any ardent supporters of either, or good housekeeping tips in this department?
I realise ammeters probably want to have undisturbed wiring runs, but thinking particularly of PLC switch terminals, which I don't particularly like fiddling with once in!
Making up loom components so have no loom constraints. (Ones in the past always seem too short)