Fabricating radius arms

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Fabricating radius arms

Tony Griffiths Offline

First Grey Mag editor

Joined: May 2018 Posts: 2,953 Threads: 558
Reputation: 20
Location: Peak District, Derbyshire
Car type: 1929 Chummy, 1930 Chummy, 1930 Ulster Replica, 1934 Ruby

23-07-2020, 04:29 PM

The answer is - as everybody comments - it's not worth bothering. I've run over some rough ground on occasions in the past, motoring with slight briskness - and never a problem.

http://lathes.co.uk

« Next Oldest | Next Newest »

Messages In This Thread

Fabricating radius arms - by Howard Wright - 23-07-2020, 08:03 AM

RE: Fabricating radius arms - by Malcolm Parker - 23-07-2020, 08:22 AM

RE: Fabricating radius arms - by Steve Jones - 23-07-2020, 09:35 AM

RE: Fabricating radius arms - by Stuart Giles - 23-07-2020, 10:46 AM

RE: Fabricating radius arms - by Tony Griffiths - 23-07-2020, 04:29 PM

RE: Fabricating radius arms - by Howard Wright - 23-07-2020, 05:02 PM

RE: Fabricating radius arms - by Dave Mann - 23-07-2020, 05:37 PM

RE: Fabricating radius arms - by JonE - 24-07-2020, 08:32 AM

RE: Fabricating radius arms - by Terrytuned - 24-07-2020, 09:49 AM