27-06-2020, 02:41 PM
I too am having a problem with the clutch lever, not clamping the shaft tight enough to stop it rotating.
I used a spare lever on a shaft and found that the clamp closes up before it grips the shaft.
To fix this I removed the bolt, used a vice to close the gap then hacksawed through the join, removing sufficient metal allowing the lever to now grip the shaft fully.
My next problem is to lift the engine high enough to remove the existing lever and replace it with the modified one.
Roger
I used a spare lever on a shaft and found that the clamp closes up before it grips the shaft.
To fix this I removed the bolt, used a vice to close the gap then hacksawed through the join, removing sufficient metal allowing the lever to now grip the shaft fully.
My next problem is to lift the engine high enough to remove the existing lever and replace it with the modified one.
Roger
Location:- Haverfordwest, Pembrokeshire.