25-05-2020, 02:15 PM
Hi Martin, I hoped I might attract your attention... ;o)
Yes, I agree, Hidem banding is an error on the drawing and it should be a piece of ply (or thin ash?) covered in headlining material. Again, the drawing is perhaps mis-leading in regard to the overhang. Having measured from the very rear of the panel into the depth of the transverse rail behind the opening, I get an inch. That almost seems to tie up with the metal strip, which 1 1/4" in width. When you make the panels, what length are they, front to back? Or anyone else? I'd like to check that measurement first if I can.
Yes, I agree, Hidem banding is an error on the drawing and it should be a piece of ply (or thin ash?) covered in headlining material. Again, the drawing is perhaps mis-leading in regard to the overhang. Having measured from the very rear of the panel into the depth of the transverse rail behind the opening, I get an inch. That almost seems to tie up with the metal strip, which 1 1/4" in width. When you make the panels, what length are they, front to back? Or anyone else? I'd like to check that measurement first if I can.