25-05-2020, 01:32 PM
(This post was last modified: 25-05-2020, 01:34 PM by Martin Prior.)
Hi Hugh.
As you may know, we make these horrible things!
With reference to your sketch, almost everything looks exactly as we make them. Only two minor details stand out; I've not seen an original roof with the metal strip below the rubber seal at the back, but it looks sensible enough. Secondly, where you have Hidem banding on the internal vertical surface, there should be a headlining-covered shaped timber strip (of that I'm certain).
The overhang of the back of your sliding panel, beyond the transverse rail looks generous. Off the top of my head, it should be about 1 1/4". I can check, if you like.
As you may know, we make these horrible things!
With reference to your sketch, almost everything looks exactly as we make them. Only two minor details stand out; I've not seen an original roof with the metal strip below the rubber seal at the back, but it looks sensible enough. Secondly, where you have Hidem banding on the internal vertical surface, there should be a headlining-covered shaped timber strip (of that I'm certain).
The overhang of the back of your sliding panel, beyond the transverse rail looks generous. Off the top of my head, it should be about 1 1/4". I can check, if you like.