15-05-2020, 01:01 PM
I am planning on making up a new insert with the lugs to hold the starting handle as in this fix:
http://www.austin7.org/Technical%20Artic...%20Handle/
Work holding will be a bit of a challenge and I'm not sure of the best tooling to remove the old aluminium to create a counterbore. I'd be interested to hear the details from anyone on here who has actually done this job. As a lathe operator I am very much the enthusiastic amateur.
http://www.austin7.org/Technical%20Artic...%20Handle/
Work holding will be a bit of a challenge and I'm not sure of the best tooling to remove the old aluminium to create a counterbore. I'd be interested to hear the details from anyone on here who has actually done this job. As a lathe operator I am very much the enthusiastic amateur.