11-05-2020, 05:44 PM
Afternoon everyone.
I'm tackling the brake shaft on the Cambridge Special at the moment. All the levers are off, it's all gone ok so far...
However, I'm now at the point where I could do with some help from those who know.
Should this shaft separate into 2 pieces? (The long slim inner and the shorter, chunkier outer)
And if it should separate, how should one go about it?
I've used gentle heat, penetrating oil and mild to reasonable force with a mallet and block of wood, and had no movement.
Any ideas or info will be very much appreciated.
Pete.
I'm tackling the brake shaft on the Cambridge Special at the moment. All the levers are off, it's all gone ok so far...
However, I'm now at the point where I could do with some help from those who know.
Should this shaft separate into 2 pieces? (The long slim inner and the shorter, chunkier outer)
And if it should separate, how should one go about it?
I've used gentle heat, penetrating oil and mild to reasonable force with a mallet and block of wood, and had no movement.
Any ideas or info will be very much appreciated.
Pete.