Thanks I will try it on the hand throttle
Do you get at the springs/ball from the upper rear of the box.? ....there are a number (3?) of hex plugs there.
I have just found the "Cornwall" article on this subject and putting in new spring & ball looks possible without removing the box. Not dropping parts in the gearbox looks like a problem! !
The plugs are straightforward, but then removing the shaft and selector etc is the clever bit! Parts cost pennies!
David
Do you get at the springs/ball from the upper rear of the box.? ....there are a number (3?) of hex plugs there.
I have just found the "Cornwall" article on this subject and putting in new spring & ball looks possible without removing the box. Not dropping parts in the gearbox looks like a problem! !
The plugs are straightforward, but then removing the shaft and selector etc is the clever bit! Parts cost pennies!
David