| The following warnings occurred: | ||||||||||||
Warning [2] Undefined variable $search_thread - Line: 60 - File: showthread.php(1617) : eval()'d code PHP 8.1.31 (Linux)
|
|
Half-shaft oil seals
|
06-04-2020, 12:47 AM
(05-04-2020, 07:21 PM)Alan Wrote: It’s not that difficult to reset the mesh, so don’t worry, but what you can do is one side at a time. Screw the adjuster all the way in assemble the axle and then screw it out until it’s just over finger tight. That puts the crown wheel in the right place. Then you can do the other side. It’s harder to explain than it is to do. Not sure I understand ? |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Half-shaft oil seals - by Peter Naulls - 05-04-2020, 05:32 PM
RE: Half-shaft oil seals - by Howard Wright - 05-04-2020, 06:10 PM
RE: Half-shaft oil seals - by Alan - 05-04-2020, 07:21 PM
RE: Half-shaft oil seals - by Bob Culver - 05-04-2020, 08:11 PM
RE: Half-shaft oil seals - by Peter Naulls - 05-04-2020, 10:58 PM
RE: Half-shaft oil seals - by Tony Press - 06-04-2020, 12:47 AM
RE: Half-shaft oil seals - by Alan - 06-04-2020, 09:34 AM
|
