31-03-2020, 10:53 PM
(This post was last modified: 31-03-2020, 10:55 PM by Tony Press.)
I wrote in that earlier exchange- dated 29- 5- 18
"Not sure how you can be sure the clutch bearing isn't being turned by the levers flying out without the mousetrap springs to hold then in place- or possibly even worse the levers are sliding around the bearing."
Obviously no one thought this was possible
"Not sure how you can be sure the clutch bearing isn't being turned by the levers flying out without the mousetrap springs to hold then in place- or possibly even worse the levers are sliding around the bearing."
Obviously no one thought this was possible