29-03-2020, 05:23 PM
Many thanks both, I think the hand done drawings are what I remembered, potentially in the BA7C newsletter many years ago.
Zeto, do you not have any way to pull the bearing back or do you just let it be pushed back by the clutch levers? I was worried about it disengaging with the cross shaft levers and turning a bit thus loosing location on the two flats?
Zeto, do you not have any way to pull the bearing back or do you just let it be pushed back by the clutch levers? I was worried about it disengaging with the cross shaft levers and turning a bit thus loosing location on the two flats?