27-03-2020, 05:15 PM
If the axle is a bit off centre, check where the springs are bolted and clamped into the chassis ends at the rear.
If you slacken the 1/2" bolt that goes through each spring, and then loosen the U clamp that goes over the spring you can get a fair bit of sideways movement once the springs are loose in the chassis end. Then re-tighten the bolts and you should be good to go.
If you slacken the 1/2" bolt that goes through each spring, and then loosen the U clamp that goes over the spring you can get a fair bit of sideways movement once the springs are loose in the chassis end. Then re-tighten the bolts and you should be good to go.