29-02-2020, 12:24 PM
I found the bearings were tight on the shaft of my 1-1/8 Phoenix. The front web did come close to the crankcase but a small chamfer fixed that.
So long as the little ends aren't tight against the pistons and there is some clearance I wouldn't think it would matter much. Possibley not worth the trouble of trying to fiddle it. So long as the crank is properly located I would probably leave well alone if it were me.
So long as the little ends aren't tight against the pistons and there is some clearance I wouldn't think it would matter much. Possibley not worth the trouble of trying to fiddle it. So long as the crank is properly located I would probably leave well alone if it were me.
Jim