25-01-2020, 08:58 AM
Can anyone advise what dimensions of the bacon slicer mounting bolts are?
I have three slicers and one magneto engine block but no matching bolts in the parts I have acquired.
They look to be 3/8 BSW, but I have two concerns:
1. If they are too long they will foul the flywheel, so getting the lengths right is essential
2. A 3/8 BSW bolt when manually threaded into the block feels a bit too loose for my comfort and I’m worried that the thread is worn to the point that there maybe not enough strength left for a good firm fit
- Andrew
I have three slicers and one magneto engine block but no matching bolts in the parts I have acquired.
They look to be 3/8 BSW, but I have two concerns:
1. If they are too long they will foul the flywheel, so getting the lengths right is essential
2. A 3/8 BSW bolt when manually threaded into the block feels a bit too loose for my comfort and I’m worried that the thread is worn to the point that there maybe not enough strength left for a good firm fit
- Andrew