18-01-2020, 12:11 PM
Thanks again for all your suggestions. I think the best bet will be to get the existing spacer plate out and have a good look at it. It maybe, with the use of one of the special gasket goos that are now available, that it will be possible to reuse it.
The block has an additional fixing stud which is from the centre main bearing retaining cap. The camshaft is to be replaced as part of the engine work. At present a standard cam is fitted. The engine was originally blown and the advice from Stuart Rolt was to use a standard cam. I have a Jack French cam which is destined for the engine.
The block has an additional fixing stud which is from the centre main bearing retaining cap. The camshaft is to be replaced as part of the engine work. At present a standard cam is fitted. The engine was originally blown and the advice from Stuart Rolt was to use a standard cam. I have a Jack French cam which is destined for the engine.