09-01-2020, 01:12 AM
Here is a few more pictures of the scuttle box being formed and folded. After the swaging was done, the curved edges were lifted and the dimples pressed in. The Die was made out of a piece of chopping board machined to the desired shape. Being all one piece the task of swaging folding and pressing proved challenging.
DSC03420.JPG (Size: 287.68 KB / Downloads: 1,799)
DSC03424.JPG (Size: 298.82 KB / Downloads: 1,803)
DSC03416.JPG (Size: 191.15 KB / Downloads: 1,801)
DSC03417.JPG (Size: 170.92 KB / Downloads: 1,794)
DSC03430.JPG (Size: 123.4 KB / Downloads: 1,803)
DSC03427.JPG (Size: 191.32 KB / Downloads: 1,812)
DSC03435.JPG (Size: 158.51 KB / Downloads: 1,809)
Next step is to do some adjusting and then move on to the rear tunnel piece over the diff.
DSC03420.JPG (Size: 287.68 KB / Downloads: 1,799)
DSC03424.JPG (Size: 298.82 KB / Downloads: 1,803)
DSC03416.JPG (Size: 191.15 KB / Downloads: 1,801)
DSC03417.JPG (Size: 170.92 KB / Downloads: 1,794)
DSC03430.JPG (Size: 123.4 KB / Downloads: 1,803)
DSC03427.JPG (Size: 191.32 KB / Downloads: 1,812)
DSC03435.JPG (Size: 158.51 KB / Downloads: 1,809)
Next step is to do some adjusting and then move on to the rear tunnel piece over the diff.