09-12-2019, 11:39 PM
I started work on one of the two stripped engines that came with my totally dismantled project. Both engines are very badly corroded, one is seized on both the crank and piston seized in block with bent con rod. The other engine looks salvageable. The block cleaned up nicely and i tried the rings in the bores and have 0.050 ring gap, a little too much i feel. The pistons are specialloid +0.040 Does anyone know if i can get +0.040 rings to suit those Specialloid pistons and where would i get them if possible?. These rings look thicker on these pistons than the other piston rings on the other engine.