24-11-2019, 10:42 AM
Hi Spannerman
I’m just doing this at the moment.
Here’s my first attempt. I need to tidy up the aluminium spacers.
I’ve used 1/4 BSF countersunk set screws through the backplate rivet holes (they need opening out to fit). The aluminium is tapped and a chase milled to locate the stays. The stays are 10mm diameter 1mm thick steel flattened to fit the chase. By tapping the aluminium you can remove the stays without disassembling the brakes.
My milling is terrible and needs to be redone but it gives you an idea.
Cheers
Howard
I’m just doing this at the moment.
Here’s my first attempt. I need to tidy up the aluminium spacers.
I’ve used 1/4 BSF countersunk set screws through the backplate rivet holes (they need opening out to fit). The aluminium is tapped and a chase milled to locate the stays. The stays are 10mm diameter 1mm thick steel flattened to fit the chase. By tapping the aluminium you can remove the stays without disassembling the brakes.
My milling is terrible and needs to be redone but it gives you an idea.
Cheers
Howard