16-10-2019, 04:57 PM
Hi All
There is definitely a hole but very small (probably about 1/16”. I cleaned a bearing a couple of days ago which, incidentally had a lashed up drip pipe. As I suggested in an earlier post I threaded a small piece of 1/4 pipe. However on this bearing housing the hole was not threaded so I had to drill and run a tap down the hole.
Cheers
Howard
There is definitely a hole but very small (probably about 1/16”. I cleaned a bearing a couple of days ago which, incidentally had a lashed up drip pipe. As I suggested in an earlier post I threaded a small piece of 1/4 pipe. However on this bearing housing the hole was not threaded so I had to drill and run a tap down the hole.
Cheers
Howard