I use a chain hoist and 18mm ring bolts in the plug holes (I used to lift them by hand but my mid-seventy-year-old back is no longer up to it!). I also free off the throttle cross shaft from the firewall.
It's then a process of a small lift,a pull forward and a tilt, repeated until the flywheel is clear of the firewall, after which it's a straight lift. It's sometime necessary to move a ring bolt forward or aft to get the right angle of tilt.
It's then a process of a small lift,a pull forward and a tilt, repeated until the flywheel is clear of the firewall, after which it's a straight lift. It's sometime necessary to move a ring bolt forward or aft to get the right angle of tilt.
Rick
In deepest Norfolk
In deepest Norfolk