01-09-2019, 06:56 PM
Having taken the old springs off yesterday and painted the new ones, I fitted them today. As suggested the grub screws were holding the pins in place. These were very tight and I planned to replace them and re-cut the threads but I couldn't unscrew them nor could I screw them in allowing them to fall out. However, I have no plan to remove them again...I hope!
A minor hitch with one of the springs was resolved and it's all ready to check over in the morning and return to the ground to see how it sits, considerably higher I hope.
A minor hitch with one of the springs was resolved and it's all ready to check over in the morning and return to the ground to see how it sits, considerably higher I hope.