30-08-2019, 08:59 PM
(This post was last modified: 30-08-2019, 09:58 PM by Bob Culver.)
Someone published a 1929 factory dwg some time ago. Front -1/4 thou, rear + 1/4 But these chosen with convenient assembly in mind. Machinerys Handbook, bearing catalogues, or Tony in OZ will give recommended fits..
For special cases there seems to be scope for using a cheaper and more readily avilable metric rear bearing. The biggest problem is finding a truly circular housing to turn out! And acheiving the precison necessary for bearing housings.
For special cases there seems to be scope for using a cheaper and more readily avilable metric rear bearing. The biggest problem is finding a truly circular housing to turn out! And acheiving the precison necessary for bearing housings.