30-08-2019, 11:57 AM
Thank you all so far.
Good idea jonE, but make sure the stick is thin enough to get to the centre of the drum face. That's were the maximum wear is.
Shoes do NOT wear all the way out to the outer edge.
Then allow for ovality, For how much will actually have to be machined out.
Then allow for anything you put on a lathe, will NEVER pick up the same centre it was made on.
It's all good fun.
Tony.
Good idea jonE, but make sure the stick is thin enough to get to the centre of the drum face. That's were the maximum wear is.
Shoes do NOT wear all the way out to the outer edge.
Then allow for ovality, For how much will actually have to be machined out.
Then allow for anything you put on a lathe, will NEVER pick up the same centre it was made on.
It's all good fun.
Tony.